Columbia-Spas Aeware Manuel d'utilisateur télécharger pdf (Page 38)

in.xm

SC - ER

System learning error

Every time a low-level option is changed, system must “learn”

currents associated to each output/load. During this learning

process, the device connected to Di (direct output, no relay) must

be disconnected IF IT DRAWS MORE THAN 0.4 AMP. If it isn’t,

system will report an SC error code.

• Disconnect load.

• Restart learning process by pressing Select key for 5 sec.

• Press Change key as many times as necessary to go through all

low level programming settings (see low level programming

section).

• When process is done, the accessory connected to Di can

be reconnected.

Keypad doesn’t seem to work!

Note: Keypad connected to in.xm is only detected when main

breaker is reset. Don’t forget to reset breaker if you’re changing

keypad model (in.k400 for in.k600).

If a keypad doesn’t seem to work:

• Verify keypad connections and try spare keypad.

• Replace keypad if problem is corrected.

• Replace in.xm if problem is not corrected.

Keypad connections

accessories corrective actions

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Pas de commentaire

Columbia-Spas Aeware Manuel d'utilisateur Page 38