Columbia-Spas Aeware Manuel d'utilisateur télécharger pdf (Page 10)

in.xm

The following material is

recommended:

4- # 10 screws of appropriate

length with round, truss or pan

head.

4- washers 1/2 OD x 1/16"

thickness.

Select the most appropriate

location on the ﬂ oor for spa

pack and ﬁ rmly attach guide

plate to wooden base with (2)

screws backed by (2) washers.

Slide back side of the unit's foot

into the guide plate. It should

easily slide into place.

Now ﬁ rmly attach unit to

wooden base by using the

remaining (2) screws backed

by (2) washers to ﬁ x the front of

the foot.

Note: The spa pack must be

installed at least 4 inches above

potential ﬂ ood level. If ﬂ oor is

on ground level, pack should

be raised at least 4 inches.

Floor installation procedure

Warning:

Beware the application of some products commonly used against

corrosion (such as WD-40 family products) could damage the

power box, due to a negative chemical reaction between some

industrial oils and its plastic enclosure. Any other materials

which may come in contact with the enclosure must be carefully

evaluated under end use conditions for compatibility.

Important!

Please note that countersunk

screws should not be used as

they can damage the power

box support.

installation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Pas de commentaire

Columbia-Spas Aeware Manuel d'utilisateur Page 10